Enhancement or Fault Number

Item  Description

When accessing EJ on server too quickly you get an error. 

*Note* you have to wait about five minutes then try to access EJ again before it will open.  

Scenario:

1.Open EJ

2.Close EJ

3.Try to access EJ again within a short amount of time  

Expected Results: EJ opens without error.  

Actual Results: Get "-2147417818 Method '~' of object '~' Failed" error.

The buttons in the lower right section of WinPoS quit working if you scroll down past the 18th item in a PLU Group 

Scenario:

1.Build a PLU Group that contains more than 18 items

2.Define the PLU Group key in menusys.mac programming as FCODE = 919 in State = 10

3.On POST press the LOOK UP button and select the Group that was created in Step 1

4.Use the DOWN arrow button and scroll down past item 18, the last entry shown on the original screen

5.Try to select item 19 

Expected Results: Pressing the ENTER key will select and ring up the highlighted item 

Actual Results: The 16 keys in the lower right section of the screen no longer function and you must stop and re-start WinPoS to get the buttons working again

Telequip - Coin changer will not work 

Scenario:

1. Load Telequip OPOS drivers and tester on either a TP3K or TP2K

2. Connect Telequip T2+Flex via USB cable to TP3K or TP2K

3. Run Telequip tester and coin change does work

4. Make entry in post configuration - Sys. Admin\POS Setup\POS Config, E-Ticket-OPOS tab, OPOS Coin Dispenser Driver Name plus check in "Use OPOS Coin dispenser"

5. Restart WinPoS

6. Ring up $5.00 grocery and tender for cash of $5.05 to force coin changer to dispense a coin

7. There are no entries in the Peripherals.Log file to indicate that V8 recognized the existence of a coin changer on V8.1.4.0-050, V8.4.6 does have coin changer entries in the peripherals.log file

8. Some piece of code for coin changers is in V8.4.6 but has not been ported over to V8.1.4.0-050 

Expected Results: Coin changer should dispense change if change at end of order

Fixed in Fuel Module

PUMPSRV (4.0.20.741)

If the Registry entry MtxLinkServer\GeneralParameters\CheckForDiscountCoupon = 1

and swipe a credit card at the pump and answer to Gas Reward Voucher is No then $0.00 value is sent to MTX but it allows fuel to be pumped with no totals getting into the system. 

Scenario:

1.Set CheckForDiscount Coupon = 1

2.Swipe Credit Card at Pump

3.Answer No to prompt for Gas Reward Voucher

4.observe $0.00 value sent immediately to MTX

5.The transaction can be continued but no totals get into the system.

Expected Results: If no is selected you should continue but totals should be sent to MTX after the sale. 

Actual Results: If No is selected a $0.00 value is sent to MTX immediately.