Enhancement or Fault Number

Item  Description

WD 236310

There are thousands of entries in the RSMSRV.log file with erroneous POS numbers and error messages.

Scenario:
1.Open the RSMSRV.log file in the PCMASTER\Log folder

Expected Results: The information in this log will contain useful and relevant information

Actual Results: This log is not being truncated and can very quickly contain thousands of entries from non-existent POS terminals like #13789.

WD 278511

Negative flag validation should be done according the flags in the batch or the PLU table flags.

Scenario:
1. In PLU batch - touch the Vendor coupon flag and make it BOLD but FALSE (will be set to 0, but this property was touched, hence will be updated with FALSE)
2. set a Negative entry flag to TRUE (it becomes BOLD and TRUE)
3. go to PLU and set for same item Negative=TRUE, Vendor coupon = FALSE (also other coupon flags should be false/unset)
4. execute the batch - it will fail with setting the Negative flag over the existing value.

WD 280084

When entering Database Management/Financial/Tender Maintenance and a tender is selected, invalid data is assigned to the tenders.  When a control check is highlighted and the backspace key is used to de-select, the control check, another control check takes its place. When you exit the screen and go back in, other control checks appear.

WD 285942

"Forgive tax on F/S partial tender by highest tax rate". If the highest tax rate amount is forgiving the tax with the partial food stamp tender, the next highest tax amount never forgives any tax even if there is still food stamp that was tendered. Part of the $11.00 in the scenario below should have forgiven the tax.

Tax 1 = 1.750%
Tax 2 = 8.250%

WD 294651

Cashier cannot cancel out of manager ID entry for override of EFT check decline.
Scenario:

1. Casher tenders check and the check is declined by MTX with the option of a manager override.
2. POS asks for manager ID and password but cashier attempts to cancel by pressing CLEAR.

Expected Results: Tender is cancelled. and POS returns to tender selection state.

Actual Results: POS re-prompts for manager ID password. Cycle continues until valid manager ID/Pwd is entered or POS is restarted.

WD 296089

Key-entry of PLU in U-Scan Direct mode after Key-entry of Member number at Robot causes Item Not Found error

Scenario:
1. Configure U-Scan to use the keypad for member number entry at start of sale.
2. Enter a Member number using the keypad.
3. Enter Direct mode on the cashier station or the robot.
4. Key-enter a PLU and press ENTER.

Expected Results: Item will sell (if it is on file, of course)

Actual Results: Yellow error box: Item not Found!

WD 296175

Need to temporarily disable support for HIP until MTX has support for HIP in WinEPS.  Currently, only 827.3 CP and higher supports HIP but no version of WinEPS supports this including the 827.2 version of WinEPS that will be certified with 8.1.6.0-050.

WD 296782

EFT Stub receipt displays the wrong information when requesting cash back with a debit card.

Scenario:
1. (WHEN USING A DEMO HOST) ring up a transaction of $5.01
2. Total order
3. Hit EFT
4. Customer swipes card selects debit enters PIN number
5. Customer selects $20.00 cash back
6. When the Is this amount okay box appears the customer selects no.
7. Cashier enters a new amount, $5.01
8. Customer gets prompted for cash back again… which they decline, no cash back this time
9. The customer gets prompted to okay the amount of $5.01
10. The register sends up a debit transaction for $5.01… however, the EFT stub receipt is incorrect: It shows the following:

Purchase $20.01

Cash back $15.00 -

Total $5.01

Expected Results: The EFT receipt will display the correct amount as follows:

Purchase $5.01

Cash back $15.00

Total $20.01 11.
Actual Results: EFT Stub receipt displays the wrong information as shown above.